Home > Linear >

2GIG-TILT1-345

2GIG-TILT1-345


 
Price: $45.15
Price Per: EA

Quantity in Stock:4

Product Code: LNR_2GIG-TILT1-345
Qty:

Description
 
Wireless Garage Tilt Sensor
The 2GIG-TILT1-345 is a wireless garage tilt sensor designed to protect a traditional overhead door or basement tilt windows for a 2GIG Go!Control panel like the GC2 and GC3 (see compatibility note below). Tilt sensors like this and the Honeywell 5822T are equipped with technology that determines the status of an overhead door by its vertical or horizontal positioning. Overhead doors are in a vertical position when closed and horizontal along the ceiling when open. When properly installed with the arrow facing up the TILT1-345 detects a fault on a garage door as soon as the upper portion of the door begins rolling back horizontally. This requires optimal placement of the sensor at the very top of the door. If the sensor is mounted lower on the door it will not show as open until that portion of the door reaches the horizontal rails. Make sure this tilt sensor is programmed to loop 1 in panel programming.

The TILT1-345 uses a standard coin cell battery (CR2032) which will operate for 5 to 8 years under normal residential use. When the prescribed voltage level is reached a low battery trouble is reported to the panel. If Alarm.com and/or central station service is configured customers will receive alerts of the low battery situation with ample time to replace the battery before the sensor stops functioning.

This tilt sensor offers a wider operating temperature range than most of the other 2GIG 345MHz RF sensor. It is optimized for garage environments that may fluctuate more drastically when uninsulated. The sensor should operate normally between 0 to 120° F degrees (0 to 49° C).

Share your knowledge of this product. Be the first to write a review »